Screenshots
BVESG /
The Alstom Metropolis C830C project is a train add-on for the Singapore Circle Line route.
This project is developed by BVESG developer SMB142J. Visit the official forum thread on SGTrains Forums for more updates on this project.
Advertisement
Version 1.0 (2 March 2018) / .7z (109MB) / Changelog >
Download Alstom Metropolis C830C 1.0 (3 March 2018)By downloading this add-on, you agree to the Terms of Use indicated below.
Advertisement
The Alstom Metropolis C830C trains are the second generation of rolling stock for the Circle Line, Singapore's fourth Mass Rapid Transit line. The trains are designed by Alstom Transport and manufactured by Shanghai Alstom Transport and Shanghai Alstom Electrical Equipment.
24 trains in a three car formation were purchased to boost the capacity of the line, and were put into service in 2015. These trains are fully automated by relying on a continuous two-way digital communication on Alstom's Urbalis 300 signalling system.
The SgATC plugin simulates the Circle Line Alstom Urbalis 300 system, including an auto mode where trains will automatically travel from one station to the next. Train doors will have to be controlled manually.
Advertisement
Whilst the train is stationary with Emergency Brakes applied, use the C1: Page Up and C2: Page Down buttons to switch between modes.
Modes available:
This mode disables the train from moving off.
The system will accelerate and decelerate the trains automatically, adjusting the speed based on track conditions. Trains will accurately and automatically stop at the stopping position. The SgATC plugin does not support automatic operation of train doors currently.
You have full control over the train in this mode. It also allows the train to pick up the speed limit and automatically prevent you from overspeeding. The train can only be operated to go forward in this mode.
In the restricted manual mode, the system completely ignores the signal aspects of the route, and allows the train to move at a maximum of 18km/h. The RMR mode allows you to reverse the train, whilst the RMF mode allows you to move the train forward.
Use the F5 (left) or F6 (right) button to control the train doors.
Use Z to increase the acceleration power, Q to increase the brakes and A to set the lever to neutral. Adjust the speed according to the speed limit indicated by the orange arrow on the speedometer.
A beeping tone will be heard when the train exceeds the speed limit.
Advertisement
The Alstom Metropolis C830C project is licensed under a Creative Commons Attribution-No Derivative Works 3.0 Singapore License.
You are free to share this project with attribution, but you may not distribute a modified version of the project. Read on >
Advertisement